Cannot Access NAS With \\NasName But Can Access Via \\IPAdress. Why?

I – Cannot Access NAS With \\NasName But Can Access Via \\IPAdress. Why?

II – How to Enable \\NasName Access Again

.

I – Cannot Access NAS With \\NasName But Can Access Via \\IPAdress. Why?

Problem;

I am able to connect to the shares using the IP address ie \\192.168.0.4\public etc but not using the NAS name ie \\nas\public.

.

II – How to Enable \\NasName Access Again

Go to Network Services] > [Microsoft networking] > [Advanced Options], and be sure these options are enable & right configured;

Other advices;

1 – Try to disable and enable the Local Master Browser, located at [Network Services] > [Microsoft networking] > [Advanced Options]

2 – Try to disable and enable the SAMBA at BONJOUR page, located at [Network Services] > [Network Service Discovery] > [BONJOUR]

3 – try to change the workgroup name of windows to be the same as NAS.

4 – Check if you have right subnet mask; subnet mask for the ethernet interface (in Control Panel, System Settings, Network) was set to a default of 255.255.0.0. When I corrected the subnet mask, the QNAP immediately became visible in the Windows Network.

Cannot Access NAS With \\NasName But Can Access Via \\IPAdress. Why?Qnap'a \\IpAdresi İle Ulaşabiliyorum Fakat \\NAS ismi İle Ulaşamıyorum?, 10.0 out of 10 based on 1 rating