Dune HD Medya Oynatıcınızı Qnap’a Nasıl Entegre Edebilirisiniz?

Configuring New Network Folder

To manually configure a new network folder (i.e. to connect a network drive to the player):

1. Enter the Main screen (root folder of the file browser).

2. Execute the “New Network Folder” action in the context menu.

3. In the appearing window, assign network folder parameters.

4. Set the “name” field to any name which you like. This name will be shown as a folder name in the file browser.

5. Set the “type” field to SMB or NFS, depending on which protocol does your network drive support.

   • If you want to connect to a Windows PC and you are not familiar with the NFS protocol, the easiest way would be using SMB – in this case you won’t need to install additional software on a PC; the built-in Windows software would be enough (for Windows 2000, XP and Vista).
   • If you want to connect to a NAS (Network-Attached Storage), and your NAS supports NFS, it is recommended to use the NFS protocol (for better performance).
   • Windows typically does not have a built-in software which implements the NFS protocol. If you want to use NFS for accessing files on a Windows PC, you may need to install and configure some thirdparty NFS server software (such as HaneWin NFS Server).

6. Enter settings specific to SMB or NFS protocol (see below).

7. Press the “OK” button on the screen. The Main screen (the root folder of the file browser) will show the new network folder.

8. Navigate into the configured network folder to browse the contents of the network drive. If an attempt to open a network folder fails with the “Cannot access network folder” message, please refer to the “Troubleshooting” section of this manual.

Using Network Browser

To browse the list of network resources accessible via SMB or UPnP protocols, use “Network Browser” item on the main screen of the player menu.

NOTE: If some network resources are not shown by the player, you may need to wait some minutes and then retry (or press the “MENU” RC button and choose “Refresh” command).